Exact Align Pro long-arm (23") parallel arm kit for John Deere XP, ME5 and ME+ planter row units on wide toolbar mounting plates. Ball bearing pivots replace the factory bushings in a complete one-row kit.
Key Features
- Complete row kit: two upper arms, one lower arm and hardware
- Pre-installed 204 series ball bearings in the pivots
- Upper arms: precision laser-cut steel
- Lower arm: ductile cast, approximately 40% heavier than the OEM part
- Made in the USA
Fits
- John Deere XP, ME5 (MaxEmerge 5) and ME+ planter row units with the long 23" parallel arms
- Wide toolbar mounting plates (arms fit inside the mounting bracket)
Replaces OEM #
John Deere A61571 (23" upper parallel arm), A84382 (lower parallel arm); also EA23PAK
Specs
- Arm length: long 23" parallel arms
- Contents: 2 upper arms, 1 lower arm, hardware
- Bearings: 204 series ball bearings, pre-installed
- Upper arms: precision laser-cut steel
- Lower arm: ductile cast, approximately 40% heavier than OEM
- Mounting: wide toolbar mounting plates
- Made in the USA
Measure Before You Order
- Measure your upper parallel arms. This kit is for the long 23" arms (John Deere A61571 upper). For the short arms (A76223 upper / A52092 lower, 15.75"), order RLPEA16PAK.
- Check your mounting plates. This kit is for wide toolbar mounting plates, where the arms fit inside the mounting bracket. It is not for narrow mounting plates.
Kit Includes
- 2 upper parallel arms (laser-cut steel)
- 1 lower parallel arm (ductile cast) with pre-installed 204 series ball bearings
- Hardware
Questions?
Call (585) 270-8047.
OEM names and numbers are for reference only.